The quicker you hang your Empowerment Boards, the quicker you’ll get to following those dreams and goals. Here are the instructions for the application of your Empowerment Boards. It’s very easy to hang your forever planners. Check out the instructions that fit your board type best!
Peel & Stick Sticker Instructions
- Before you begin installing your sticker, prepare your surface and clear the work area. Clean and properly prepare the wall surface with a sponge and alcohol or all-purpose cleaner.
- Peel about 12” of the backing away from the paper. Apply the corner of the sticker to the wall, You can reposition it if needed to ensure it’s straight.
- Working from top to bottom, pull the backing away as you evenly press the sticker to the wall. Do not force, let gravity assist you.
- If need to Use a plastic smoother, work your way down the strip in a back and forth motion, smoothing the material to the wall and pushing out any air bubbles.
How to Remove the Sticker
1. Feel free to apply heat
For safest removal, start with the use of heat as this will help release the adhesive from the decal. Heat one edge of the decal for about 30-60 seconds using a blow dryer approximately 6-12″ away from the decal.
2. Gently lift the heated edge
Gently lift the heated edge and slowly pull toward you slowly until the sticker is completely removed.
3. Clean any remaining residue with soap and water
If any adhesive residue is present after the decal has been removed, wash the application surface with soap and water.
Hard Board Instructions
Command™ Picture Hanging Strips make decorating quick and easy. One click tells you Picture Hanging Strips are locked in and holding tight. Best of all, when you are ready to take down or move your pictures, they come off cleanly—no nail holes, cracked plaster or sticky residue.
To Apply
- First, clean the wall with isopropyl rubbing alcohol by wiping gently. Don’t use household cleaners like wipes or sprays because they leave behind a slippery residue.
- Separate the strips. Press two strips together until they click.
- Remove one of the green liners and press onto the frame. Repeat with the other pairs of strips as shown above. Place the lower pair of strips about 2/3 down from the top of the frame. Check your package for the correct weight limits
- Remove the remaining liners and press frame on the wall. Press each side of the frame firmly against the wall for 30 seconds.
- To ensure the adhesive will hold, remove the frame by grabbing the bottom corners and peeling the frame up and away from the wall. Don’t pull straight off. Now, press the strips that remained on the wall for 30 seconds. Make sure to press the entire strip.
- Wait 1 hour before reattaching the frame. Line up the strips on the frame with the strips on the wall. Press until each pair of strips click and lock in place.
To Remove
- Remove the frame by grabbing the bottom corners and peeling the frame up and away from the wall. Don’t pull straight off.
- Remember to never pull the strips towards you or peel from the wall. Always pull straight down as slow as you can.
- Slowly stretch the strip straight down, keeping your hand against the wall as you go. Keep stretching up to 15 inches.